Wireless Microphone Problems

COMPATIBLE, BUT NOT QUITE ENOUGH

PROBLEM: There are different degrees of frequency compatibility. If you know exactly what the operating situation is, you might be able to be a bit more aggressive and squeeze a few more systems into the space. The key is understanding the trade-offs.

One important assumption that is made by most frequency compatibility software is that all receivers will be turned on and unmuted all the time (even though some transmitters will occasionally be turned off), making it important that none of the receivers is picking up an intermodulation signal that might be heard as noise.

Therefore, the software needs to leave ample space between the intermodulation signals and the wireless mics themselves.

If you assume that the sound system operator will take a more active role, however, you may find that more systems are actually compatible. In this scenario, it's assumed that the operator will mute any receiver that's not actually in use at the moment — and that all transmitters will be left on at all times during the show. The distance between each transmitter and the receiving antennas is also assumed to be similar. These assumptions would make sense in a Broadway theater installation; however, the same performance might not reasonably be expected in a school auditorium operated by volunteers with little or no training.

Interference symptoms are much worse when the transmitters are located very close to the receiving antennas or to each other — or when high-powered transmitters are being used. This is why it's much more difficult to get 40 wireless systems to work in a theater (many transmitters very close together at various distances from the receiver) than it is to get them to work in a school with one system in each classroom (transmitters far apart from each other but fairly close to its own receiver).

SOLUTION: To get a balance of high performance with the maximum number of systems, make sure that the level of compatibility between frequencies is appropriate to the expected use of the systems. Keep transmitters at least 10 feet from the receiver antennas. If the transmitter's RF output power is adjustable, use the lowest transmitter power that is necessary to cover the expected distance between the transmitter and receiver.